A sensor can be installed either by a surface or wall-mount method and is commonly dependent on its application use. Both techniques can be used together if desired.
Wall mount: Sensor device is mounted directly to a wall surface by way of a keyhole mount. If a secure-mount is required, the screw mount installation can be applied with use of two #6" drywall screws and anchors.
Surface mount: Sensor device is mounted to the outside surface of a fixture, wall, or other type of unit using the supplied 3M™ Dual Lock™ Tape strips.
Where a sensor device is mounted impacts its use and operation. Be sure to identify a location that meets the following guidelines.
Complete the steps below to mount a sensor device.
Remove the device cover; simultaneously press the two tabs located on the top side of the device.
Insert the 3.0v Primex Lithium/Iron Disulfide Battery Pack or two 1.5v Lithium AA batteries. Follow the symbols showing the correct way to position the positive (+) and negative (-) ends of the battery pack.
Located to the lower-right of the battery compartment, set the battery on/off switch to the Up (On) position.
Replace the device cover.
Mount the device using either of the methods below.
Determine the mounting location by referencing the key-hole slot located on the back of the device.
Mark and pre-drill a mounting hole into the wall surface. 1.75 in. distance between the two key-hole slots.
Insert a wall anchor into each mounting hole.
Insert a screw into the wall anchor, leaving approximately 3/8 in. of the screw head exposed for hanging.
Attach the device to the wall surface by sliding the key-hole slot onto the mounting screw. Ensure the device is properly secured and level.
Prepare the mounting area to ensure maximize adhesion. If there is moisture, dry the area first.
Press a black fastener strip and a clear adhesive strip together.
Remove the backing off of the clear adhesive strip(s) and affix to the back of the device. It's recommended to place the strip(s) horizontally.
Remove the backing off of the black fastener strip and affix to mounting surface; creating a secure mount between the device and mounting surface.
Verify the strips are securely fastened together and the device mount is secure.
Apply power to the device; AC or PoE. It's recommended to dress the cables with self-adhesive hook-and-loop mounting tape.
When power was applied, the device automatically initiated a check-in to your OneVue account. Verify the device LCD displays Signal OK, which indicates it has successfully checked-in.
If the LCD screen does not display Signal OK, it's recommended to initiate a manual check-in. This will validate the device can connect to the network at its installation location. Press and release check-in button . The device emits a series of audio beeps indicating its connection sequence. During an active check-in connection, additional pressing of the check-in button is ignored.