A dual-sided clock consists of two clocks and a Dual Clock Kit, which can be either ceiling or wall mounted. Using the kit, combine two clocks to create a dual-sided clock.
Place each clock in the housing with the 10/11 and 4/5 numerals over the brass posts.
Route the clock power cords to the left, right, or center position. For right or left routing, remove the dual mount bracket cover and thread the cord through the clearance hole in the bracket. Lift the power cord out of the way, then slide the bracket cover back onto the dual mount bracket.
Measure and drill holes into the wall or ceiling to align with the mounting plate hole spacing measurements.
Attach the mounting plate to the wall or ceiling using the provided anchors and screws.
Slide the assembled dual clock bracket over the four tabs on the mounting plate. A tap with a rubber mallet on the clock bracket may be required to seat the clock bracket assembly fully into place.
Examine the mounting plate to ensure the bracket is fully engaged. The small hole in top side of the mounting plate should be visible and fully exposed. To increase the security of the clock assembly, a common screw may be inserted into the hole and screwed into the wall.
Route the power cords as desired and apply AC power. The clocks set to the correct time after they receive a valid time signal from the system Transmitter.