When the network that devices connect to require an EAP-TLS client certificate, the certificate must be uploaded to a Primex network device using the Primex Device Configuration software. This procedure is required during installation and when updating a device's certificate.
Primex Device Configuration software is installed on your computer.
Primex device USB configuration cable (supplied with each device order)
EAP-TLS certificate file (.der)
If the device is battery-powered, temporarily remove its batteries.
Plug the Primex device USB configuration cable into a USB port on your computer.
Plug the configuration cable mini-USB connector into the device USB mini port.
The device automatically powers up, detects the connection to your computer and enters configuration mode.
Open the Primex Device Configuration software. Go to All Programs > Primex > Primex Device Configuration or from your computer desktop, double-click on the Primex Device Configuration icon.
From the Enter Password window, enter the password.
Factory default password (case sensitive): Primex1
Select Connect. A connection between your computer and the device is established.
Verify the notification area located in the lower-left of the screen, displays Connected to device on COMx, which indicates the connection has been established ( x identifies the current COM port in use).
Select the RADIUS Certificate tab.
For each of the certificates, select Open and select the certificate file (.der file required).
Select Write Certificates and Private Key.
Select Disconnect. The connection between the software and the device is ended.
Remove the USB connection between the device and your computer.
Apply power to the device. When power is applied, the device automatically initiates a check-in to your OneVue account.
Verify that Signal Ok is displayed on its LCD screen and successfully checked-in to OneVue.