Learn how to add a new Bridge to OneVue or update its primary settings with the OWDC app.
The following details what's required to configure a Bridge with the OWDC app.
Connection cable (not supplied)
The cable connects the Primex device to your Android device and also provides the power source to the Primex device during configuration.
During configuration, a Bridge is assigned to an existing Network Profile.
From the OWDC app, you cannot create a new Network Profile. Before you begin, from OneVue verify a Network Profile exists or create a new Network Profile. From OneVue, go to Devices > Networks.
For a Non-DHCP network, during configuration you will be required provide the device's static IP address.
New Clock Time Zone
Time zone that Sync Bluetooth Clocks are set to the first-time they connect to the Sync Bluetooth mesh network. When set to Default, clocks are set to time zone in the account profile.
Commonly identifies its install location.
The OneVue Business Unit assigned to the Bridge. From the app, you cannot create a new Business Unit.
From your Android device, open the OWDC app.
Enter your OneVue username and password (required to be assigned to the Account Admin Role).
Remove AC power from the Bridge. During the next step, it receives power from its connection to your Android device. If battery power is enabled, leave this on.
Set Bridge into configuration mode > connect Bridge to your Android device using a USB OTG or a USB C cable (dependent on your device).
App displays "Add Device" and "Con" displayed on Bridge LCD screen, indicating it's in configuration mode.
Enter its settings.
Name: name of the Bridge, which commonly identifies its install location.
Network Type: select the type of network the Bridge will connect to.
Select Network: select a network (displays the network profiles available in OneVue).
New Clock Time Zone: select your local time zone. When set to Default, set to your OneVue account time zone.
Select Next to continue.
The app configures Bridge and displays its configuration status.
Do not remove the connection between the Bridge and your Android device until prompted.
When the Disconnect Device message appears > remove USB connection between the Bridge and your Android device > and re-apply AC power to the Bridge.
Once disconnected, the app verifies the Bridge successfully checked-in to OneVue. If after 15 minutes it does not check-in, the app displays a status message.
If applicable, it may also take time to download the latest firmware (Bridge LCD displays UP).
You can now configure additional devices or close the app when you’re done.