A Message Board can be installed by way of a wall-mount or the optional ceiling/suspended mount.
The power plug may be removed and cord cut to length for hardwired (pigtail) installation. Pigtail installation requires a 120V~ power line in a junction box installed by a licensed electrician. Leave a minimum of 6 in. (15 cm) of cord inside the junction box.
Installation is completed with the supplied wall-mount bracket kit.
Locate wall studs and align each bracket to a stud location. Brackets are to be spaced at a minimum of 16 inches (40 cm) separation and level in respect to each other.
Mount brackets to wall using the supplied #10 screws 1-1/2” long or an alternate fastener appropriate for the wall construction.
Attach brackets to Message Board using the supplied 5/16"-18 screws and washers. Insert screws from the top of bracket through the slot and screw into T-Nuts located in the center channel on the top-side of the Message Board.
Adjust position and tighten both screws to secure Message Board.
Insert supplied Ethernet cable into Message Board and network port.
Apply power to the Message Board.
When power is applied, the Message Board attempts to connect to the Ethernet network. When connected to the network, it briefly displays its network IP address, downloads its OneVue configuration settings, connects to a NTP Server to obtain UTC time, and synchronizes the received time to its time zone.
Verify its connection to Ethernet network - indicated by what's shown on its display.
Successful connection - time is displayed on line 1 and line 2 displays Your Message Board has been successfully connected! (all digits are green in color).
Failed connection - time is displayed on line 1 and date is displayed on line 2 (all digits are red in color).
Installation is completed by attaching threaded rods or eye bolts to the T-Nuts located in the center channel on the top-side of the Message Board, permitting it to be suspended from a ceiling.
To mount, screw either 5/16"-18 threaded rod or eye bolt or another threaded piece (not supplied) into the T-Nuts located on the top-side railing slot.
From OneVue (https://console.primexonevue.com), go to Devices > Message Boards> select the Name link of the Message Board, by default its Name is its 12-character Device ID (MAC address).
From Enable Time Zone/NTP Change, select the checkbox and update the settings.
When a change is downloaded to the Message Board, it continuously reboots for approximately 6 minutes. Once downloaded, deselect the checkbox and select Save to stop the device from rebooting. 12 minutes after a setting change is saved, the change expires; under the assumption the change was downloaded to the Message Board.
If the Message Board did not download the change, verify the device has an Ethernet connection and repeat this procedure.