Learn how to add a new PoE Clock/Timer to OneVue or update its network and primary settings with the OneVue Wired Device Configurator (OWDC) app.
The following details what's required to configure a clock/timer with the OWDC app.
Cables required (not supplied)
Required to establish a wired connection between your Android device and the clock/timer.
A PoE Digital Clock/Timer requires two cables, both an OTG Data Cable with Extra Power (either Micro USB or USB C) and a Mini-USB to USB cable. The Data Cable connects to your Android device and the Mini-USB to USB cable connects the data cable to the clock. Recommended OTG Data Cable with Extra Power cables available online: Option 1: Micro USB 2.0 OTG Host Adapter with USB Power or Option 2: Micro USB Host OTG Cable with USB Power. Use of an USB wall outlet adapter is only required when the wired connection does not supply enough power to power on the clock.
During configuration, the clock/timer is assigned to an existing Network Profile.
From the OWDC app, you cannot create a new Network Profile. Before you begin, from OneVue verify a Network Profile exists or create a new Network Profile. From OneVue, go to Devices > Networks.
For a Non-DHCP network, during configuration you will be required provide the device's static IP address.
Unique name of the clock, which commonly identifies its install location.
OneVue User Profile
Your OneVue User Profile is required to be assigned to the Account Admin role.
From your Android device, open the OWDC app.
Log in: enter your OneVue username and password . You must be assigned to the Account Admin role.
Establish a wired connection between the clock and your Android device.
From the backside of the clock, remove its setting panel access cover to locate its Mini-USB port.
USB Extra Power: use of an USB wall outlet adapter is only to be used when the wired connection does not supply enough power to power on the clock.
Add Device screen displays its primary settings.
Clock name: commonly identifies the clock installation location.
Network: select a network.
Select Create Clock. The app configures the clock and displays its configuration status.
Do not remove the connection between the clock and your Android device until prompted.
When the Disconnect Device message appears, remove the wired connection between the clock and your Android device.
Once disconnected, the app verifies the device successfully checks-in to OneVue. If after 15 minutes it does not check-in, the app displays a status message.
If applicable, it may also take time to download the latest firmware (clock/timer displays UP).
You can now configure additional devices or close the app when you’re done.