Articles in this section

See more

Tilt bracket mount (72MHz Digital Clock/Timer)

  • Updated
Follow

Complete the instructions illustrated below to mount a Levo Series Digital Clock/Timer using the supplied tilt mount bracket.

  • Mount the tilt bracket directly to the wall with the four #10 screws and anchors (supplied).

    Hard-wired installation requires a 120V~ power line in a junction box installed by a licensed electrician. The tilt bracket has a center pass-through hole for the 120V~ pigtail. If a junction box is present, the tilt bracket also has mounting holes spaced to allow direct attachment of the tilt bracket to the cover plate screw holes on the junction box.

Note

The RJ45 jack for the network cable is on the bottom of the clock/timer. Most building codes prohibit running network cables through the same junction box as line voltage.

digital-tilt-mount.png

Upon applying power to the digital clock/timer or when pressing the Reset button located in the setting panel, the clock initiates its power up sequence as described below.

  1. All 8 LED segments display 8’s with a red dot on the bottom right of each of the two hour digits and one at the second or last minute digit.

  2. All LED segments display dashes and then dashes with a colon between the hours and minutes.

  3. Once the clock/timer receives a signal from the Transmitter, the LED segments display the time received from the Transmitter’s time source and a flashing red dot appears at the bottom right of the second hour digit for three minutes.