To access the CompuSync Receiver menu, press the Menu button located on the front of the receiver. By pressing and holding the Menu button, the receiver cycles through the menu options.
Note
Changes made in the menu will be saved when the menu is exited.
Display |
Menu |
Description |
|---|---|---|
Ch |
Channel Number |
The CompuSync Receiver is set by default to scan for the first available frequency. The hardware can, however, be set to pick up a signal from a specific Transmitter. While in the Channel menu option, if there are no changes made in a minute of entering a menu section, it will time out and save the displayed value, exiting the menu mode. If a value is changed while cycling through the menu, it will be saved and continue to cycle. |
tESt |
Test |
Test menu allows the user to hear audible beeps with a valid time/date reception. This will occur 5 seconds after the test menu is selected. It will continue to be in this mode until the menu button is pressed again, leaving the menu mode and returning to normal mode. While in test mode, it will remain in the selected mode until the menu button is pressed again to exit. |
LtU |
Last Time Update |
Last Time Update menu allows the user to see the last time update, time and date (cycles every second). This will occur 5 seconds after last time update menu is selected. The unit will remain in this mode for a minute, wherein it will time out and return to the menu mode. |
Soft |
Software Revision |
Software Revision menu allows the user to see the software revision on the unit. This will occur 5 seconds after last time update menu is selected. The unit will remain in this mode for a minute, wherein it will time out and return to the menu mode. |
dst |
Daylight Saving Time |
Daylight Saving Time Calendar menu allows the user to see the current Daylight Saving Time calendar in use. This will occur 5 seconds after last time update menu is selected. The unit will remain in this mode for a minute, wherein it will time out and return to the menu mode. |
donE |
Done |
Done menu allows the user to exit the menu mode. This will occur 5 seconds after the done menu is selected returning to the normal mode saving all settings. |
The internal dip switch settings define the unit's time and RF channel scanning settings, as defined in the table below.
Note
To access the dip switch panel, remove the cover of the receiver.
Switch |
Sets the... |
ON Position |
OFF Position |
|---|---|---|---|
2 |
Time/Date |
displays only the time. |
displays the current time for 8 seconds and the date for 2 seconds. |
3 |
12/24 Hour |
display the time in 24 hour format. |
display the time in 12 hour format. |
4 |
RF Channel Scan |
enable the scan and look for a suitable channel. |
disable the scan and only look on the selected channel for time/date/event info. |
5 |
DST |
DST is disabled |
DST is enabled |
Note
Settings are only read on reset. Switches 6, 7, 8 do not apply to this application.