Parameter |
Specification |
---|---|
Operating Frequency Range |
72MHz |
Channels |
49 channels available (pre-programmed prior to shipping) |
Channel Bandwidth |
20KHz |
Maximum Transmission |
1 Watt (at Transmitter) |
Radio Technology |
Narrowband FM |
System Impedance |
50 Ohms |
Voltage |
120VAC |
Frequency |
50/60 Hz |
Current Draw |
5 Watt: 0.9A 30 Watt: 1.41A |
Wattage |
5 Watt: 169.2W 30 Watt: 180W |
Amplifier Output Bandwidth |
>20 MHz maximum |
Amplifier VSWR (Maximum) |
4:1 |
Amplifier Spurious Emissions |
-60 dBc |
Amplifier Output Power to External Antenna |
5 Watt: 8.0 to 8.5 Watts at enclosure antenna connection. 5.6 to 6.0 Watts at antenna. 30 Watt: 45 to 47 Watts at enclosure antenna connection. 31.8 to 33.2 Watts at antenna. |
Connector at Antenna |
N-Male |
Bluetooth Technology |
Bluetooth® low energy (v5) wireless technology. To allow pairing with OneVue Device Configurator (ODC) app for configuration and setting management. |
User-defined Settings |
Locally at device with OneVue Device Configurator (ODC) app
OneVue software
|
Dimensions |
22 in. W x 17 in. H x 22 in. D (55.88 cm W x 43.18 cm H x .55.88 cm D) |
Weight |
55 lb. (24.9 kg) |
Power Supply |
Input: 120 VAC, 50/60 Hz, 0.6 Amp. Output: 9 VDC, 1.78 Amp. 6 ft. (1.83 m) cord |
Front Panel |
Four LED status indicators (Power, Transmit, Caution, Error) and Bluetooth labeled push-button to pair with the Primex OneVue Device Configurator (ODC) app. |
Rear Panel |
DC Input: connection to supplied AC power supply Network LAN port: RJ-45 Ethernet, 10/100 Mbps, 802.3 Ethernet External Antenna connector (coaxial, n-male) GPS IN port: MiniDIN 7-Pin Baseboard Monitor port (MiniDIN 9-Pin) Dry Contact Closure Terminal Block with removable connector: for use with OneVue Notify with Critical Notifications Pinhole button: initiate manual check-in to OneVue (press and release with jewelers screwdriver or other small object) |
Operating Range |
32° to 122° F (0° to 50° C), non-condensing environment |
Warranty |
5 Year |
Canadian Notice: 5 or 30 Watt Transmitter with an external antenna: The manufacturer rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
All specifications are subject to change without notice.