The LCD display of a Temperature & Humidity Sensor provides a visual reporting of its readings and current operating state.

Segment |
Description |
---|---|
Temperature (°F or °C) |
The last sampled ambient temperature reading in either Fahrenheit or Celsius. A sample reading it taken every 60 seconds. The display units (°F or °C) is configured within the sensor profile in your OneVue account. |
Humidity (%RH) |
The last sampled relative humidity reading; RH% The LCD display alternates between the sampled temperature and humidity readings every 15 seconds. |
No Signal |
Indicates the last check-in to your OneVue account failed. For wireless network use, a failed check-in may be due to the device is not within range of a wireless signal or the wireless signal strength is not adequate for normal operation. For PoE or Ethernet use, a failed check-in may be due to a network connection cannot be established. If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state. |
Signal Ok |
Indicates the last check-in to your OneVue account was successful. |
LOW -Battery Level |
The device is in an Alarm state due to its estimated battery life is less than 25%. To avoid loss of battery power, be sure to replace its batteries. Requires 2 AA Lithium AA batteries. The use of alkaline batteries is not recommended. If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state. |
Lbat |
The device is an Alarm state due to its battery level is critically low. Readings are not logged or transmitted your OneVue account during this state. Replace its batteries immediately. Requires 2 AA Lithium AA batteries. The use of alkaline batteries is not recommended. |
Up |
Indicates a firmware update is currently being applied to the device. Do not remove power during this state. When the firmware update is complete, UP is no longer displayed. A firmware update is being applied to the device. Readings are not displayed, sampled, or logged during this mode. |
Con |
The device is in configuration mode. The config icon is also displayed. Readings are not displayed, sampled, or logged during this mode. |