A Transmitter's LED status indicators continue to flash until all logged errors have been cleared. Clearing an error code stops the yellow and red LEDs from flashing.
From the front panel, press right arrow
button once to access the Main Menu.Use the down arrow button to select Diagnostic Error Codes, then press the right arrow
button once.Use the down arrow button to scroll to the error, which is indicated by a preceding dot next to the error.
Press the right arrow
button once. The display will show when the error was logged. Note the time and data of the error.Press the right arrow
button once.Display will read: “Clear all errors?. Press the right arrow
button once.-
“Yes” and “No” are displayed with a selection arrow.
Selecting "Yes" followed by the pressing the ENTER button clears the errors.
Selecting “No” followed by pressing the ENTER button cancels the process and takes you back to the main menu.
Wait several seconds for the time/date to be displayed.
Note
If the LEDs continue to flash, repeat procedure as there may be additional errors to be cleared. If same errors continue to be logged, additional troubleshooting may be required.