Articles in this section

See more

Replace a Probe

  • Updated
Follow

A specific procedure is required when you are either installing a new Temperature Sensor or replacing a probe. This procedure ensures OneVue is updated with the probe serial number. The probe serial number is printed on the tag affixed to the probe's cable.

When installing a new temperature sensor with a probe...

When replacing a probe...

Wait for Err to display on the sensor's LCD screen.

Remove the existing probe from the sensor jack and wait for Err to display on the sensor's LCD screen.

Proceed by completing the steps below.

  1. Insert the probe into the sensor probe jack.

  2. Press and release the sensor Check-In button button-check-in.png (up arrow) to send the new probe serial number update to OneVue.

  3. For 1 second, press and hold the sensor Silence button silence.png (bell icon). A single beep is emitted when the reset is complete.

  4. From the LCD screen verify the readings are displaying (Lo, Hi, and Cur).

  5. Verify the probe serial number update: From OneVue go to Monitoring > Monitored Assets > select the Name of asset the sensor is monitoring > from the Sensor Type section, select the Temperature link. From the sensor profile's Probe Life section, verify the Probe Serial Number is the same as the number printed on the tag attached to the probe.

    sensor-probe-life.png

Related articles